CREE SEC-EDG Edge Series Wall Pack Security Light Fixture (Product Configurator)

CREE SEC-EDG Edge Series Wall Pack Security Light Fixture (Product Configurator)

  • $24.39
  • Save $419


ContractorsCommercial Input:
CREE's Security Edge series wall pack fixtures delivers exceptional efficiency and durability made with rugged die cast aluminum and weathertight LED driver compartments. Featuring a slim, low profile design and aluminum housing, the SEC-EDG series includes a lightweight mounting box for installation and can be used as an uplight or downlight. Customize the fixture with the options above to best fit your security lighting needs.

Construction & Materials:
• Slim, low profile design
• Luminaire sides are rugged die cast aluminum with integral, weathertight LED driver compartment and high performance aluminum heat sinks specifically designed for LED applications
• Housing is rugged aluminum
• Furnished with low copper, light weight mounting box designed for installation over standard and mud ring single gang J-Boxes
• Luminaire can also be direct mounted to a wall and surface wired
• Secures to wall with four 3/16" (5mm) screws (by others)
• Conduit entry from top, bottom, sides, and rear
• Allows mounting for uplight or downlight
• Designed and approved for easy through-wiring
• Includes leaf/debris guard
• Exclusive Colorfast DeltaGuard® finish features an E-Coat epoxy primer with an ultradurable powder topcoat, providing excellent resistance to corrosion, ultraviolet
degradation and abrasion. Black, bronze, silver and white are available
• Weight: See Dimensions and Weight Chart on page 1
Electrical System:
• Input Voltage: 120–277V or 347–480V, 50/60Hz, Class 1 drivers
• Power Factor: > 0.9 at full load
• Total Harmonic Distortion: < 20% at full load
• Integral weathertight J-Box with leads (wire nuts) for easy power hook up
• Integral 10kV surge suppression protection standard
• To address inrush current, slow blow fuse or type C/D breaker should be used
• Maximum 10V Source Current: 20 LED (350mA): 10mA; 20LED (525 & 700 mA) and 40-120 LED: 0.15mA
Regulatory & Voluntary Qualifications:
• cULus Listed
• Suitable for wet locations
• Meets FCC Part 15 standards for conducted and radiated emissions
• Enclosure rated IP66 per IEC 60529 when ordered without P, PML or ML options
• 10kV surge suppression protection tested in accordance with IEEE/ANSI C62.41.2
• Luminaire and finish endurance tested to withstand 5,000 hours of elevated ambient salt fog conditions as defined in ASTM Standard B 117
• DLC qualified. Exceptions apply when ordered with full backlight control. Please refer to www.designlights.org/QPL for most current information
• Dark Sky Friendly, IDA Approved. Please refer to www.darksky.org/ for most current information
• Meets Buy American requirements within ARRA

Questions & Answers

Have a Question?

Be the first to ask a question about this.

Ask a Question